When Raymond mill is running, consistently loud hit sound comes from the machine, the main reason is some liner bolts is loosen. You are able to judge the place of liner bolt based upon the sound resource, and after that find it and tight it up. The temperature of ball mill and motor bearing is growing and exceeds regulation. In this case, you could touch the machine to judge the heated components are more than entire or simply partly. Settle the issues with these procedures as follows. Check out the many lubricating points, should the applying oil specs are complies with products directions or not.
Test if your lubricating oil and grease turns into negative. Check out if Raymond milllubricating road is clogged, and if lubricating oil right enters into lubricating point. Oil shortage will cause machine overheated. Side gap concerning ball mill and bearing bush is too smaller, and also the gap of bearing bush and bearing is as well substantial. As a result, the get hold of factors are too significantly to type evenly oil movie to the bush. The main reason may also be the amount of roller bearing lubricating oil is too significantly or too little. Also a lot amount oil will create heat and hardly dissipated. Also little oil will induce bad lubrication. So, we ought to include ample oil as regulation, typically the amount is 1/3~1/2 in the bearing gap.
Two ends of ball mill physique is as well tight in sealing, or sealing physique get in touch with directly with bearing, can cause overheated. the above complications really should be solved according to various purpose. Ball mill reducer bearing overheat. ept checking it in accordance to ball mill heating check out procedures, we ought to check gasoline discharging port of reducer. If it is clogging, we should really keep it clear. Ball mill vibrates when motor starts reducer, the key causes are: The gap of linked two wheels is also small, as a result, it can’t compensate driving power. The method of shaft coupling correcting is not right, which leads to unconcentric of two bearings. The connecting bolt of shaft coupling is not fixed tight equally, plus the tight degree is different. Ball mill bearing outer ring is flexible. tlement: adjust gap of two wheels as instruction statement, and make them concentric. Fix tight the linked bolts with equal force.